Key Fob Keyless Entry Remote Shell Case & Pad fits Chevy Colorado Venture / GMC Canyon / Hummer H3 / Pontiac Montana / Oldsmobile Silhouette / Isuzu

It is a little more complicated than I expected. I don’t use QR codes as well as maybe I should. Some instructions for it would have been helpful.

Looked just like the OEM ones and performed just the same.

Defective. The place were the battery terminal goes isn't cut out of the plastic so there's more way to install it. The first photo is the new cover and the 2nd photo is my old cover for comparison of where the terminal should go.

Perfect

came as described. works great

The item fit as expected. Now my keyfob is brand new. Easy installation

Was easy to switch over!

I got this case because the ring hole snapped off my old one, so I had to carry it in my pocket and couldn't attach it to my keys. The case worked, looked nice, and had all the necessary parts. But the internal shell was too small, I spent a a few minutes trying to get the old circuit board in by force but was afraid I was going to snap it in half trying. And I tried a few different ways to get it in, from trying it with the rubber button pad inside, then trying to put it in the pad, and then the pad into the case, but it still was just barely too small. I ended up using my knife to shave a bit of the internal plastic off the wall to make it fit; regardless, it was still very tight. The other problem was with the back part, the little metal where the battery touches were not properly attached, and after further inspection, that's because the slits for the arms were not cut out, again, I used my knife to cut them, so it would fit. Unfortunately, the metal piece that came with the fob had the prongs too tight, so I tossed it and used the one from my old case. Overall, it works fine but be prepared to use your old parts, and don't be afraid to use a little force with it.